Model of microprocessor centrifugal equipment for honey extraction

Authors

  • Eugen RĂDUCA Babeș-Bolyai University, Faculty of Engineering, Piaţa Traian Vuia, nr. 1-4, 320085, Reşiţa, e.raduca@uem.ro https://orcid.org/0000-0002-5489-3647
  • Mihaela MOLNAR Babeș-Bolyai University, Faculty of Engineering, Piaţa Traian Vuia, nr. 1-4, 320085, Reşiţa, m.molnar@uem.ro (* corresponding author)
  • Nicolae Titu FARA Eng., TMK Reșița, Str. Lalescu Traian, 36, Resita, fara.nicolaetitu@yahoo.com

DOI:

https://doi.org/10.24193/subbeng.2020.1.18

Keywords:

model, extraction, honey, microprocessor

Abstract

The paper presents a model of centrifugal equipment for extracting honey made around an ATmega 328 processor, with which the Arduino Uno module is equipped. The created model is functional, being tested, and the practical results obtained would allow the transition to prototype equipment. The created model is flexible, allowing to obtain flexible operating cycles, with variable speeds, soft settable, in both directions of rotation. The number of frames from which the bee honey can be extracted is variable depending on the juicer itself, which is driven by the motor.

References

Răduca E., Electronică aplicativă, Editura Orizonturi Universitare, Timisoara, 2010.

https://www.theengineeringprojects.com/wp-content/uploads/2018/06/Introduction-to-Arduino-UNO.jpg (downloaded at 2020).

Fara N.T., Model de automatizare a unei centrifuge de stors miere, Dissertation Paper, “Eftimie Murgu” University of Reşiţa, 2020, pp. 44-50.

https://diyi0t.com/arduino-uno-tutorial/ (downloaded at 2020).

https://ardushop.ro/2506-thickbox_default/modul-comutator-pwm-de-putere.jpg (downloaded at 2020).

https://ardushop.ro/158-thickbox_default/modul-releu-2-canale.jpg (downloaded at 2020).

https://ardushop.ro/134-thickbox_default/lcd-1602.jpg (downloaded at 2020).

https://ardushop.ro/226-thickbox_default/modul-i2c.jpg (downloaded at 2020).

STUDIA UBB ENGINEERING, Volume 65 (LXV), No. 1, November 2020

Downloads

Published

2020-11-23

How to Cite

RĂDUCA, E., MOLNAR, M., & FARA, N. T. (2020). Model of microprocessor centrifugal equipment for honey extraction. Studia Universitatis Babeș-Bolyai Engineering, 65(1), 163–170. https://doi.org/10.24193/subbeng.2020.1.18

Issue

Volume 65, No. 1, November 2020

Section

Articles

License

Copyright (c) 2020 Studia Universitatis Babeș-Bolyai Engineering

Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.